RF Module Replacement Procedure Follow
Overview
This Help Center article contains information specific to replacing the RF Module in your EcoTech Marine product. Below you will find a list of instructions as well as a video tutorial for each product that is upgradeable to Mobius.
VorTech/Vectra:
- Disconnect the power cable from the VorTech controller
- Remove the 3 screws from the backside of the controller casing
- Slide off the knob
- Separate the 2 halves of the controller casing
- Remove the cable from the corresponding controller notch
- Remove the controller board from the casing
- Remove the RF Module from the controller board
- Install the new RF Module on the controller board (carefully align pins before depressing)
- Install the controller board in the controller casing (align screw holes and cable notch)
- Assemble the controller casing and hand tighten screws
- Install knob and power on the controller (W in the upper right corner will illuminate if installed properly)
Radion:
- Disconnect your Radion from power
- Remove lens frame screws from the underside of your Radion (Cluster screws do not need to be removed)
- Locate the RF Module and carefully remove
- Align the pins and install the new black RF Module with the same orientation as the previous green RF Module
- Place the lens frame and tighten the lens frame screws
- Power on your Radion