Follow

My VorTech Controller is flashing Red/Green?

A Red/Greeb flashing on a VorTech controller indicates a stall error has occurred.  To troubleshoot, power down your VorTech then remove the wetside from your aquarium.  Power the VorTech back on while the wetside is still disconnected to test if this resolves the issue.  Should the controller go back to normal operation, this would indicate your wetside needs to be fully disassembled and cleaned.  Start by soaking your wetside in a 50/50 mix of hot water and vinegar.  After a 30 minute soak, fully disassemble and clean all components of your wetside.  The video link below provides a complete tutorial on how to disassemble most VorTech wetsides.  

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments