Follow

New Wetside Break-in Procedure

Any new VorTech wetside will require a break-in period before operating at it's most quiet.  To properly break-in your wetside, please follow the steps below:

  1. Measure your aquarium's wall thickness and ensure you are using the correct spacer
  2. Mount the Dryside securely using the hanging tabs (Dryside wire should face upwards)
  3. Set the Controller to Constant Mode at it's lowest speed (Green dial)
  4. Gradually increase the speed while still in constant mode over a 2 week period

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments